Kodak 605 Photo Printer Sensor Error 06




Yüklə 8.05 Kb.
tarix11.04.2016
ölçüsü8.05 Kb.
Kodak 605 Photo Printer

Sensor Error 06
Diagnostic information


A2

Cutter Position Detection Sensor connector poor connection, burnout

Defective sensor


DC Motor ASSY (Cutter) connector poor connection, crossover burnout

Defective DC Motor ASSY



Check for proper connection of crossovers (CN17-CN80, CN17-CN81, CN17-CN82) between Cutter Detection Sensor and Board HSSV10-CONT-F ASSY. In case of abnormality, manufacturer repair is necessary. Check for proper connection of crossovers (CN12-CN50) between DC Motor (Paper Cutter Unit) and Board HSSV10-CONT-F ASSY. In case of abnormality, manufacturer repair is necessary. If the problem is solved by replacing Paper Cutter Unit 9 , Paper Cutter Unit is defective. Please replace.(see Service Parts Replacement Procedure 12-1) 

The error is dealing with the Paper Cutter. Follow the procedure below to try to resolve the issue. If this procedure fails to resolve the problem the paper cutter will need to be replaced.




  1. Remove the front & left side covers.

    1. Front cover – remove 4 screws

    2. Left side cover – remove 4/5 screws




  1. Cutter unit remove 2 screws.





  1. Inspect sensor connections



  1. Inspect Connector on Digital board

      1. Open Door Paper supply

      2. Remove 3 screws

      3. Digital board protection plate





      1. Check connector at CN-17




  1. Check the paper path thru the cutter. Remove any obstructions in the paper path.

Note: If the above procedure does not clear the problem a new cutter will be needed.

Let me know and I will arrange for a new cutter to be sent to Germany.
Jim Hargreaves

WW Service & Support



Service Engineering


Verilənlər bazası müəlliflik hüququ ilə müdafiə olunur ©azrefs.org 2016
rəhbərliyinə müraciət

    Ana səhifə